Honda TRX ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I need some jetting help the bike bogs when you jump on it and pops a lot when you let off but it idles smooth.... the air filter is a K&N in I'm thinking a stock box ... white brothers e-series exhaust Elevation is 457 feet and I only run non ethanol gas in it.... I'm looking for a starting point.... what the main and pilot jet should be and where the E-clip should be.... thank you
 

·
Super Moderator
Joined
·
4,642 Posts
Starting point is needle clip in middle (3rd groove), pilot jet is whatever it is now (since it idles fine, main jet should be about 100 (stock is 95) then go up from there as required. You almost never have to go bigger on the pilot jet (it is the one it idles on) and the needle clip controls how it runs at steady 1/2 throttle setting. Main jet is for full throttle at top speed.

Make sure your float level is correct and while you use non ethanol gas, use 93 octane
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top