Honda TRX ATV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
i have new tie rods for a 2001 honda 400ex. When i try to remove the bolt from the steering stem it turns in the housing. Can anyone recommend a way to take it out? i might just end up cutting the end
 

·
Super Moderator
Joined
·
4,647 Posts
If you mean "turn with-in the joint" - yes

If you mean "move from side to side" - no

If you mean "is the stud loose with-in the hole" - no: the stud is supposed to be torqued in the hole so it is tight, then a cotter pin is used to keep the nut from loosening.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top