Best plastics for ex
1 - 2 of 2 Posts
If you are trying to keep an OEM style plastic, I would just stick to OEM. Most aftermarket OEM style plastic I have encountered are flimsy compared to the real deal.
This would probably get more hits if it weren't in the Dyno/Tuning section though
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Jet kit 400ex
Dyno/Tuning RoomI have a 2000 400ex that I just bought. I am going to be putting a Lexx slip on exhaust on and an Uni Air filter. Any suggestions on jet size or a kit I could buy to have a little bit of a range of sizes- 2
- 106
-
416 jetting
Dyno/Tuning RoomI have a 07 400ex that I am building and I have some questions on jetting? So I redid the lower end and put hot rod crank with all new bearings and seals. I am running a CP 12:5:1 +1 valves stage 3 Webb cam hardened rockers and shortened Value guides Lightened fly wheel Full exhaust open airbox...- 1
- 239
-
400ex only starts with throttle open and backfires/pops like crazy
Dyno/Tuning RoomHello new to the trx forum and new to the Hondas. I recently purchased a 2002 400ex of a guy that could not get it to run. I was told the piston,rings,timing chain,stator,cdi,coil,spark plug, and rectifier was all new. So i decided to start with the timing. I put the piston on top dead center...- 2
- 936
-
400ex jetting question
Dyno/Tuning Roomi have a 01 400ex with a 440 big bore kit that im going to put a lexx mxe pipe on and run a uni air filter and i would like to know what jets to run. my elevation is right at 1050 feet above sea level. to run it temporarily could put on the uni with the stock slip on without messing anything up?- 7
- 1K
-
Jetted 400ex
Dyno/Tuning RoomWhat jets should I be running with my mods 99 400 ex 416 bore stage 2 hot cam ported and polished head sparks racing header to power core 4 muffler mesh air box lid foam filter currently running 42 pilot and 155 main.. Any help appreciated thanks- 2
- 615
Join now to ask and comment!