Honda TRX ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hello everone i,m called bucket i am 58 year,s old. i have worked on bikes and atvs for years.i am a retired truck driver. i have 07 trx 400ex the left back wheel hub will not stay tight.i tighten the nut all the way up put carter pin in and it still gets loose.icant figure it out.any suggestions will be appreciated . bucket im out of here/:confused:
 

·
Super Moderator
Joined
·
4,642 Posts
I'm going to guess you have a wrong hub, a wrong nut, or the hub or the axle or both are worn out. When you tighten the hub, is the nut a flanged nut and do you use a torque wrench or an impact wrench? It's best to impact them tight and then tighten a bit more to get the cotter pin in. Don't loosen to put the cotter pin in. Good luck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top