Honda TRX ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
Help! This hub has been soaking in liquid wrench for two days now. The hub puller in the picture has been on under tension with an impact wrench for 24 hours, removed and re-tightened at least twice in that time. I've tried smacking it from two sides simultaneously with ball peen hammers while under tension and also heating it until the liquid wrench began to smoke also while under tension and it's not budging. Anyone have any advice or suggestions?


Sent from my SM-G920V using Tapatalk
 

·
Super Moderator
Joined
·
4,643 Posts
Heat the hub with an acetylene torch till red hot (axle should not get quite that hot) - if that doesn't work, remove the axle from the carrier and have the hub pressed off.

Keep the splines greased and the hub nut torqued to specified value and future removals are not so exciting.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top