Honda TRX ATV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have an 07 400EX and I have a Pro Design killswitch, and the installation instructions are useless. Has anyone ever installed one on a 400EX? I still have the electric start, and want to keep the use of my key. It is a normally open circut I think.
 

·
Registered
Joined
·
40 Posts
Take the positive wire on the kill switch and splice it in to the black and yellow positive coil wire and just ground the ground wire to ur frame
 

·
Super Moderator
Joined
·
4,643 Posts
Wire the new switch to the black/white wire and the green wire going to the key switch. The key switch has 4 wires - red, black, black/white and green. Red is positive, green is ground, black becomes hot (positive) when the switch is turned on, black and white is ignition, the ignition wire is connected to ground when the switch is turned to the off position.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top