Honda TRX ATV Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
over this past weekend i did some repairs to my 2004 300ex. one of which was new A arm bearings on the upper arm of my quad, and this is my question, when i put the new bearing in i grease it up really good and when i put the new dust seals back in i put them in and drove them all the way in against the bearing, when i took the old ones out they were clocet to the ends and not shoved in, and now i am wondering if i did it wrong?:mad:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top