Honda TRX ATV Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Dose anybody know of any cheap nerf bars with heel guards that will fit on a '03 trx300ex? or any other model of atv whose nerf bars fit a 300ex? I have heard rumors of ltz400 nerf bars fitting a 300ex. I would like to stay below $200 but could make some exceptions. Any of the ones i've found have been anywhere from $300-$500 but at 14 years old i dont exactly have that kind of cash. I'd appreciate any advice on this. But if there arn't any nerf bars/heel guard combinations avalible, a nice set of medal heel guards and seperate nerf bars would be fine too just because the stock heel guards are cheap plastic.
 

· Registered
Joined
·
11 Posts
Discussion Starter · #5 · (Edited)
these ones are pro peg bars. I'm still debating about these or some normal bars that work with the stock heel guards that are $170 less. I have seen people running nerfbars without any type of heel guards. Is this something that works well or should I stay away from a setup like that?
 

· Registered
Joined
·
11 Posts
Discussion Starter · #7 ·
Ok well when I ride I tend to kick up a lot of rocks so I'll probably stick with keeping the heel guards. Also because I hope to enter into a GNCC race in the near future and I will deffinatly need them then
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top