[hondaguy94]

i am trying to install a proarmor tether on my 05 450r and the directions tell me to ground one wire on the frame and connect the other wire to the wire that runs from the coil to the stator. however there is no wire that runs directly from the coil to the stator. but there is a wire that runs from the coil to the ignition control module, can i splice the tether into that one? hopfully someone can help me haha, thanks!

 

[mud99]

That sounds like it may work like that.

 

[69quadracer]

Find the two wires that go to your on/off switch on the handle bars you will have to take it apart to see them cut them loose or splice in to them that is how i did my 07 TRX450ER

 

[jhnharvy773]

i am trying to install a proarmor tether on my 05 450r and the directions tell me to ground one wire on the frame and connect the other wire to the wire that runs from the coil to the stator. however there is no wire that runs directly from the coil to the stator. but there is a wire that runs from the coil to the ignition control module, can i splice the tether into that one? hopfully someone can help me haha, thanks!

are you done went to your mechanic? i think 69quadracer is right. my mechanic do this on my atv and finally its okay now.

"Too much is never enough"
ATV Control Modules
05 450r
Athena 480
hrc kit with hc stage 2
13t front
full big gun race pipe
Big Gun over rev box
tons of heart and BIG BALLS