Honda TRX ATV Forum banner

Steering stem and bar setup??

2595 Views 7 Replies 5 Participants Last post by  teamelvadoq19
hey i am just wondering what length stem you guys run on your trx450 with what bars? i have a +1 but to get the height i need atv high bend i prefer low bend bars but with a +1 its too low. how do the flex bars compare for height against the atv high bends?
1 - 8 of 8 Posts
I am not sure. I run a stock stem on my 400, If I ever need a new set of bars I will get fex bars though, They are awesome! My freind is 6ft4in tall and runs a =1 stem and flex bars and says it is comfy for him. I am 6ft and I have rode his quad. Its not bad for me either.
  • Like
Reactions: 1
I run a +1 Houser stem and ProTaper fat bars in a low bend to help keep center or gravity low and like them i am 5'8" tall but when i do buy some new bars i am going with the ATV4Play bars they have clicker adjustments itstead of elastomers have hear are way better the Flexx bars.
  • Like
Reactions: 1
awesome i just checked them out $295 mrsp

New ATV Four-Play Products

i am 5'11'' i had fitted low bend one they just seems too low with a +1 stem they ended up being 15mm higher than standard.. not sure what that is in inches
  • Like
Reactions: 1
I agree, they do look good.
i ride a trx450 with a plus 2 roll design stem on fast flexx bars!
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top