Honda TRX ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Im trying to replace the steering stem bearing but my snap ring broke and now its stuck inside. Any help or suggestions on how to take out a broken snap ring would be greatful
 

·
Registered
Joined
·
55 Posts
Try a very small flat head screwdriver "careful not to break the tip of the driver off" to get one side lifted up and needle nose pliers to grab it when you get it lifted and tear that out of there don't worry about destroying the old C Clip because you can get new ones for less then .30 cents at any hardware store.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top