Honda TRX ATV Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Im fixing a 93 trx 300ex it has, a loanstar rear end, the bearings in the rear are done. Its so bad im going to have to replace the bearing housing. I cant get the sprocket spindal off the axel. any one know any tricks? I think I have to take it of to put the new bearing housing on? I did not get the new housing yet but I will be ordering it soon!

thanks,
kevin
 

·
Registered
Joined
·
10 Posts
not sure how to do that but go to hondaatvforum.net theres a lot more people on there to help you....but keep using this site to most of us here are there to
 

·
Registered
Joined
·
1,049 Posts
Im fixing a 93 trx 300ex it has, a loanstar rear end, the bearings in the rear are done. Its so bad im going to have to replace the bearing housing. I cant get the sprocket spindal off the axel. any one know any tricks? I think I have to take it of to put the new bearing housing on? I did not get the new housing yet but I will be ordering it soon!

thanks,
kevin
Do you have a manual???? It will help!
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
Its all after market. I do not have a manuel, im going to go get one on pay day! If I dont figure it out by then!! I posted on the honda forum to thanks!!
 

·
Registered
Joined
·
718 Posts
You dont have to take it off. Take every thing loose from the break side and the axle will pull out to the left. Its not that hard of a job.
 
1 - 7 of 7 Posts
Top