Honda TRX ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hello gents. As I have now been made aware the grab bar is part of my subframe (2014 TRX400X). This in my opinion is a poor design by Honda and should have been a bolt on option like every other quad they make. My question is have any of you cut the original bar off and welded in tabs to accept a 450r or 250r grab bar? If so could you answer a few questions.

How far from the end of the grab back towards the subframe do you cut?

Would the width of the subframe match up to either a 250r or 450r?

Is one more desirable than the other?

What are you guys using for tabs? Are you just fabricating them or do they come with a kit?

Lastly anyone have any pictures of the process or completed process?


Thanks!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top